Power Locks

NOTES:
- All malfunctions that can be recognized by the central locking system control module and printed out on the VAG1551 Scan Tool (ST) are listed per the 5-digit DTC.
- If switch or activating element DTCs are stored, troubleshooting procedures should include reading measuring value block. Read Measuring Value Block (Function 08)
- Before replacing a suspected malfunctioning component, check all related wiring connections, harness connections and Ground (GND) connections per the appropriate wiring diagram.
- After repairs, use the VAG1551 scan tool to check and erase DTC memory
- DTC memory stores all static and sporadic malfunctions as DTCs. A malfunction is recognized as static if it exists for at least 2 seconds. If a static malfunction is no longer present after 2 seconds it will be classified as sporadic and the letters "/SP" will appear on the upper right side of the scan tool display.
- After switching the ignition on, all DTCs present are set as sporadic, and are only stored as static DTCs if they are still present after the check.
- If a sporadic malfunction no longer occurs for 50 driving cycles, the DTC is erased.





VAG1551 scan tool display: 01360 & 01361

1) The DTC is stored if there is Ground (GND) connection for longer than 1 minute, e.g. because of incorrect operation of the central locking system. Carry out malfunction repairs only when there are complaints, otherwise just erase DTC memory. Erase DTC Memory (Function 05)





VAG1551 scan tool display: 01362 & 01363

1) The DTC is stored if there is Ground (GND) connection for longer than 1 minute, e.g. because of incorrect operation of the central locking system. Carry out malfunction repairs only when there are complaints, otherwise just erase DTC memory.
2) The DTC is stored if the input status of the central locking system pump has not changed before and after the closing and opening of the central locking system.





VAG1551 scan tool display: 01364

1) The DTC is stored if the input status of the central locking system pump has not changed before and after the closing and opening of the central locking system





VAG1551 scan tool display: 01365

1) The DTC is stored if there is Ground (GND) or positive (B+) connection for longer than 1 min., e.g. because of incorrect operation of the central locking system. Carry out malfunction repairs only when there are complaints, otherwise just erase DTC memory.




VAG1551 scan tool display: 01366,01367 & 01368



VAG1551 scan tool display: 01369 & 01370



VAG1551 scan tool display: 01371,01372 & 01373



VAG1551 scan tool display: 01374 & 01389