A/T Clutch Pressure Control Solenoid Valve A, B, C, and D Test

A/T Clutch Pressure Control Solenoid Valve A, B, C, and D Test

1. Connect the HDS to the DLC (A) located under the driver's of the dashboard.





2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting Testing and Inspection.

3. Select Clutch Pressure Control (Linear) Solenoid Valve A, B, C, or D in the Miscellaneous Test Menu on the HDS.

4. Test A/T clutch pressure control solenoid valve A, B, C, or D with the HDS.

- If the valves test OK, the test is complete. Disconnect the HDS.
- If the valves do not test OK, follow the instructions on the HDS.
- If the valves do not test OK, and the HDS does not determine the cause, go to step 5.

5. Do the battery removal procedure Removal and Replacement.

6. Remove the air cleaner Service and Repair.

7. Remove the intake air duct.

8. Remove the battery heat shield.

9. Remove the auxiliary under-hood fuse/relay box.

10. Remove the battery base.

11. Disconnect the A/T clutch pressure control solenoid valve A, B, C, or D connector.





12. Measure the A/T clutch pressure control solenoid valve A, B, C, or D resistance between connector terminals No. 1 and No. 2.





- If the resistance is out of the standard, replace the secondary valve body Secondary Valve Body Replacement.
- If the resistance is within the standard, go to step 13.

13. Connect a jumper wire from the negative battery terminal to solenoid valve A, B, C, or D connector terminal No. 2, and connect another jumper wire from the positive battery terminal to connector terminal No. 1.

- If an operating sound is heard, the solenoid valve is OK. Reconnect the connector, and install all removed parts.
- If no operating sound is heard, replace the secondary valve body Secondary Valve Body Replacement.