AcuraLink Control Unit (XM Receiver) Removal/Installation

AcuraLink Control Unit (XM Receiver) Removal/Installation

With AcuraLink

NOTE: The AcuraLink must be reactivated by Acura Client Services when:

- The AcuraLink control unit (XM receiver) is replaced.
- DATA RESET was selected while in the self-diagnostic function.
- Vehicle ownership changes.

1. Remove the passenger's rear side trim panel.

2. Loosen the nuts (A).





3. Pull the AcuraLink control unit (XM receiver) (B) out, then disconnect the connectors from the AcuraLink control unit (XM receiver), and remove it.

4. Install the AcuraLink control unit (XM receiver) in the reverse order of removal.

NOTE: If you replaced the AcuraLink control unit (XM receiver) make sure it has the latest software Programming and Relearning.

5. Call XM Radio 800-852-9696 to update the client's account with the new XM/HIP serial number. Also call Acura Client Services 800-382-2238 to reactivate the AcuraLink.