Front Passenger's Airbag Replacement

Front Passenger's Airbag Replacement

NOTE: If replacing the front passenger's airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3minutes before starting work.

2. Remove the glove box Glove Box Removal / Installation.

3. Disconnect the dashboard wire harness 4P connector (A) from front passenger's airbag 4P connector.






4. Remove the two screws, then remove the passenger's dashboard ducts (A, B).






5. Detach the clip (A), then remove the mounting nuts (B) and the mounting bolts (C) from the bracket (D).






6. Remove the mounting nuts (A) from the front passenger's airbag (B), then remove the front passenger's airbag.






Installation

1. Place the front passenger's airbag (A) into the bracket. Install the front passenger's airbag new mounting nuts (B) to the specified torque.






2. Install the bracket (A) with the new mounting bolts (B) and the new mounting nuts (C) to the specified torque, then install the clip (D).






3. Install the passenger's dashboard ducts (A, B) with the two screws.

NOTE: Make sure the passenger's dashboard ducts are connected securely.






4. Connect the dashboard wire harness 4P connector (A) to the front passenger's airbag 4P connector, then reinstall the glove box Glove Box Removal / Installation.





5. Install the glove box Glove Box Removal / Installation.

6. Do the battery terminal reconnection procedure.

7. Clear any DTCs with the HDS.

8. After installing the front passenger's airbag, confirm proper system operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.