Air Bag Deactivation Indicator: Service and Repair

Passenger's Airbag Cutoff Indicator Replacement

1. Remove the dashboard center vent Dashboard Center Vent Removal/Installation.

2. Disconnect the 6P connector (A) from the passenger's airbag cutoff indicator (B).





3. Push out the passenger's airbag cutoff indicator from behind the dashboard center vent (C).

4. Reinstall the parts in the reverse order of removal.

5. After installing the passenger's airbag cutoff indicator, confirm proper system operation:

- Clear any DTCs with the HDS.
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.