Side Airbag Replacement
Side Airbag Replacement
NOTE: If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.
Removal
1. Do the battery terminal disconnection procedure, Procedures then wait for 3 minutes before starting work.
2. Remove the seat assembly. Front Seat Removal/Installation
3. Detach the clips (A) and harness holder (B) of side airbag harness from the seat frame.
4. Pull out the seat-back cover/pad as needed. Front Seat-Back Cover Replacement
5. Release the reinforcing cloth rear hooks (A) from the seat-back frame (B).
6. Remove the two mounting nuts (C) and the side airbag (D).
Installation
NOTE:
- If the side airbag lid is secured with tape, remove the tape.
- Do not open the lid on the side airbag cover.
- Use new mounting nuts tightened to the specified torque.
- Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
- Be sure to install the harness so that it is not pinched or interfering with other parts.
1. Place the side airbag (A) on the seat-back frame. Install the two new side airbag mounting nuts (B).
2. Install the reinforcing cloth rear hooks (C) in the seat-back frame (D).
3. Install the seat-back cover/pad. Front Seat-Back Cover Replacement
4. Install the clips (A) and harness holder (B) of side airbag harness to seat frame.
5. Install the seat assembly. Front Seat Removal/Installation
6. Do the battery terminal reconnection procedure. Procedures
7. Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.
8. Clear any DTCs. Initial Inspection and Diagnostic Overview
9. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6 seconds and then go off.
