Driver's Airbag Replacement

Driver's Airbag Replacement

NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel.






3. Remove the two TORX bolts (A) using a TORX T30 bit.

4. Remove the driver's airbag (B).






Installation

1. Place the driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B).
NOTE: Make sure the clearance (C) between the steering wheel and horn pad is the specified value.











2. Connect the driver's airbag 4P connector (A) and horn switch 1P connector (B), then install the access panel (C) on the steering wheel.

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. After installing the airbag, confirm proper system operation:
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6 seconds and then go off.

- Make sure the horn work properly.

- Make sure the steering wheel switches work properly.