Driver's Dashboard Undercover Removal/Installation

Driver's Dashboard Undercover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the dashboard or the related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the driver's dashboard undercover (A).
-1 Turn the lock knob (B) 90 °.
-2 Gently pull down the rear edge to detach the clip.
-3 Disconnect the footwell light connector (C) and the harness clip (D).
-4 Pull the undercover rearward to release the brackets (E) from the pins (F).

2. Install the undercover in the reverse order of removal, and note these items:
- If the clip is damaged or stress-whitened, replace it with a new one.

- Push the clip into place securely.

- Make sure the footwell light connector is plugged in properly.

- Make sure the brackets are installed securely on the pins.