Passenger's Side Vent Removal/Installation

Passenger's Side Vent Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the dashboard or the panels.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove these items:
- Center trim Dashboard Center Trim Removal/Installation

- Passenger's dashboard trim Passenger's Dashboard Trim Removal/Installation

- Glove box Glove Box Removal/Installation

2. Remove the screw (A) securing the duct (B) from glove box opening. Remove the screws (C) securing the passenger's side vent (D).






3. Pull out passenger's side vent (A) to detach the clip.

4. Install the vent in the reverse order of removal, and note these items:
- If the clip is damaged or stress-whitened, replace it with a new one.

- Push the clip into place securely.