Driver's Power Seat Motor Test

Driver's Power Seat Motor Test

1. Remove the driver's seat. Front Seat Removal/Installation

2. Disconnect the connector from each power seat motor.
NOTE:

- For the recline motor, remove the seat-back cover. Front Seat-Back Cover Replacement

- All connectors are terminal side of male terminals.









3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.

4. If the motor does not run or fails to run smoothly, replace:
- Slide motor Front Seat Slide Motor Replacement

- Front up-down motor Front Seat Frame Replacement

- Rear up-down motor Front Seat Frame Replacement

- Recline motor Front Seat Recline Motor Replacement

NOTE: The front and rear up-down motors are part of the seat frame.