Switch, Hazard Warning Signal Flasher, Replacing

Switch hazard warning signal flasher, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work
Remove the loudspeaker grille. Lift up the loudspeaker and / or the mounting for the display screen. See Display screen / loudspeaker, RTI (road traffic information), replacing Service and Repair.

Removal




Press out the switch for the hazard warning signal flasher.
Disconnect the connector.

Installation
Connect the connector.
Press the switch for the hazard warning signal flasher into place.

Finishing work
Install the loudspeaker and / or the mounting for the display screen. See Display screen / loudspeaker, RTI (road traffic information), replacing Service and Repair.
Test the function.