Connector Type 2

Connector type 2

Special tools:
951 2632 Terminal removal tool 951 2632 Terminal removal tool
951 2633 Terminal removal tool 951 2633 Terminal removal tool
951 2639 Terminal removal tool 951 2639 Terminal removal tool
951 2852 Terminal removal tool 951 2852 Terminal removal tool
951 2853 Terminal removal tool 951 2853 Terminal removal tool

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Disassembly

Disassembling secondary lock

Pin housing




Release the front housing section on the pin housing by pulling out the rear catches while at the same time pressing the housing section forwards.

Socket housing




Release the catches and pull out the secondary lock. Use tool: 951 2853 Terminal removal tool 951 2853 Terminal removal tool or an electrician's screwdriver, see the graphic.

Disassembling primary lock




Use tool: 951 2632 Terminal removal tool 951 2632 Terminal removal tool , 951 2633 Terminal removal tool 951 2633 Terminal removal tool and 951 2639 Terminal removal tool 951 2639 Terminal removal tool to remove the primary lock, as graphics.












Alternatively use tool: 951 2852 Terminal removal tool 951 2852 Terminal removal tool , see graphic.

Note! Tool 951 2852 Terminal removal tool 951 2852 Terminal removal tool can only be used for socket housings.

Assembly

Assembling primary lock
Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.

Assembling secondary lock
Press the secondary lock into place.