Part 1
Multimedia system, RSE, two screens, with two players, (Ch 175379-)
INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
Multimedia system, RSE, two screens, with two players, (Ch 175379-)
- Tightening torque screws: 40 Nm (29.5 lbf.ft.).
- Tightening torque screws: 40 Nm (29.5 lbf.ft.).
Repeat the method steps for the other seat.
- Set the ignition key to position 0.
- Disconnect the battery negative lead.
Note! Wait at least three minutes before unplugging the connectors or removing other electrical equipment.
Note! The SRS system remains active for a brief period after power is disconnected. Thus, wait three minutes before starting work.
- Loosen the connector by unscrewing the screw.
Applies to cars without seat belt tensioners in seats
Applies to cars with seat belt tensioner in seat
Applies to cars with seat belt tensioner in seat
Applies to all models
- Lift out seat.
- Repeat the method steps for the other seat.
- Use tape to protect the tunnel console.
- Remove the panel.
- Remove the screws.
- Unplug the connector.
- The component must not be reused.
- Install the component from the accessory kit.
- Secure the connectors with butyl tape.
- Reinstall the removed part.
- Ensure that no part of the cable harness is trapped.
- Secure the cable marked "Passenger side/RH" with a cable tie.
- Position the control module where the image shows.
- Position the excess where the image shows.
- Route the cable marked "Driver side/LH" between air duct and climate unit over to the left side.
- Position the cable harness as illustrated.
- Secure the cable marked "Driver side/LH" with a cable tie.
- Cut off foam tape excess.
- Route the cable marked "Passenger side/RH" between air duct and climate unit over to the right-hand side.
- Position the cable harness.
- Secure the 2 cables at the existing cable harness using a cable tie.
- Secure the 2 cables at the existing cable harness using a cable tie.
- Fasten the 2 cables to the harness in the seat's cable harness with a cable tie.