Part 1
Multimedia system, RSE, two screens, with two players
INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
Multimedia system, RSE, two screens, with two players
Note! Some steps in these installation instructions are presented with illustration.
- Tightening torque screws: 40 Nm (29.5 lbf.ft.).
- Tightening torque screws: 40 Nm (29.5 lbf.ft.).
Repeat the method steps for the other seat.
- Set the ignition key to position 0.
- Disconnect the battery negative lead.
Note! Wait at least three minutes before unplugging the connectors or removing other electrical equipment.
Note! The SRS system remains active for a brief period after power is disconnected. Thus, wait three minutes before starting work.
- Loosen the connector by screwing out the screw.
Applies to seat without belt tensioner
Applies to seat with belt tensioner
Applies to all models
- Lift out seat.
- Repeat the method steps for the other seat.
- Use tape to protect the tunnel console.
- Fasten the connector with butyl tape.
- Secure the cable marked "Passenger side/RH" with a cable tie.
- Route the cable marked "Driver side/LH" between air duct and climate unit over to the left side.
- Place the control module between air duct and climate unit.
- Fasten the control module against the air duct with a cable tie.
- Secure the cable marked "Driver side/LH" with a cable tie.
- Place fuse holder and connector under the mat.
- Route the cable marked "Driver side/LH" under the mat and on to the seat's cable harness.