Component Tests and General Diagnostics

Checking front parking assistance camera

Self-test
Infotainment control module (ICM) diagnostic test for front parking assistance camera can only detect faults when a self-test of the control module has been started. A fault code is set if the self-test detects a fault. To start self-test and check fault codes belonging to the front parking assistance camera, proceed as follows:
Rectify in the following order:
- Click on the VCT2000 symbol to start self-test of the control module.
- Go to the tab DIAGNOSTICS/DETAILS and click on Update to perform a new fault code read-out.
- Go to the tab DIAGNOSTICS/TROUBLESHOOT and check if fault codes belonging to the front parking assistance camera have been set.









Is relevant fault code set?

Yes - Fault-tracing

No - Fault-tracing

-------------------------------------------------

Fault-tracing
Fault trace these diagnostic trouble codes.

Continue - FAULT FOUND

-------------------------------------------------

Fault-tracing
Press the button for the front parking assistance camera on the Climate control module (CCM).





Is the text "Front Camera" displayed in the top left corner of the screen?

Yes - Fault-tracing

No - Fault-tracing

-------------------------------------------------

Fault-tracing
Clean the camera lens. Use a soft rag or moist sponge, so that it is not scratched.
If this does not help, replace the front parking assistance camera,





Continue - FAULT FOUND

-------------------------------------------------

Fault-tracing
The fault seems to be in the button for the front parking assistance camera on the Climate control module (CCM).
Fault trace according to DTC instructions for CCM-U200223.





Continue - FAULT FOUND

-------------------------------------------------