Fault-Tracing Information

Fault-tracing

Fault-tracing information

Note! This trouble code is only relevant for troubleshooting and action in the following cases:

- The trouble code is active in the present driving cycle and has been active for a longer period of time.
- The customer experiences malfunction that can be attributed to the trouble code.
In other cases, the DTC does not indicate a fault and must therefore be ignored and only erased.

Do you want to continue fault-tracing?

Yes - Checking the wiring and terminals

No - DONE

-------------------------------------------------

Checking the wiring and terminals








- Ignition off, wait for 15 seconds.
Check the battery voltage.
Check the charging function of the generator (GEN).
- Disconnect the connector for Supplemental restraint system module (SRS).
Check voltage feed and ground connection for Supplemental restraint system module (SRS).
Check voltage feed and ground connection for Central electronic module (CEM).
Remedy as necessary.

Other information
- Connection of breakout box, supplemental restraint system module (SRS) Connecting The Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification, supplemental restraint system module (SRS) Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Fault-tracing and testing the battery Fault-Tracing And Testing The Battery
- Checking the supply voltage/ground terminal Checking Supply Voltage/Ground Terminal, Supplemental Restraint System Module (SRS)
- Air bag supplemental restraint system Service and Repair
- Wiring harness supplemental restraint system (SRS) Wiring Harness Supplemental Restraint System (SRS)
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring and terminals

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------