Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information SRS-U210100

Condition
The Supplemental restraint system module (SRS) is continuously supplied with necessary information from the Central electronic module (CEM) via CAN communication.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The control module's configuration does not correspond with the vehicle's vehicle configuration.
- Incorrect value runs longer than 0.5 seconds.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition position II and III. Only during start-up of the supplemental restraint system.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Incorrect software in the Supplemental restraint system module (SRS).
- The vehicle's vehicle configuration file is incorrect.
- Damaged central electronic module (CEM).

Fault symptom[s]
- SRS warning light on
- PAD lamp is on
- SRS warning message displayed