Fault-Tracing Information

Fault-tracing

Checking software
In connection with reading the vehicle configuration, the Phone module (PHM) has registered that a parameter in the vehicle configuration contains an unspecified value.
Remedy the fault by loading new software into the Central Electronic Module (CEM).

Continue - Verification

-------------------------------------------------

Verification




Verification




In order that the diagnostic trouble code (DTC) can be reread, the Phone module (PHM) must be restarted. Click the VCT2000 symbol to restart the control module and to erase and read out DTCs again.

Note! After erasing DTCs there is a delay to ensure that the diagnostics for the Phone module (PHM) have been carried out.

Check that the current DTC has disappeared or changed status from permanent to intermittent fault.





Are the diagnostic trouble code (DTCs) still stored?

Yes - No Fault Found

No - FAULT FOUND

------------------------

No Fault Found - Information

-------------------------------------------------

Information

Attempt New Test - Checking software

-------------------------------------------------