Fault-Tracing Information

Fault-tracing

Vehicle configuration error




- Ignition on.
This fault code is set if vehicle configuration from Central electronic module (CEM) is not the same as is stored in Park Brake Module (PBM), or read-in of vehicle configuration done in connection with software download is not performed correctly. This means that you have to do another reading of the vehicle's configuration.
Perform another reading of the vehicle's configuration by clicking on the symbol for VCT2000.

Hint: In connection with another reading, trouble codes may be set in other control modules. These diagnostic trouble codes shall be deleted without action.






Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Ignition on.
Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.





Are the diagnostic trouble code (DTCs) still stored?

Yes - Fault-tracing information

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Vehicle configuration error

-------------------------------------------------

Fault-tracing information
Fault-trace the central electronic module (CEM).

Continue - Fault-tracing information

-------------------------------------------------