Fault-Tracing Information

Controller area network (CAN) fault-tracing

Information




- Ignition on.
The diagnostic trouble code indicates that a control module from another vehicle has been installed. Load new software into the control module.

Other information
- Go to the tab software and program the control module with the latest software.

Continue - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------

Checking the diagnostic trouble codes (DTCs)




- Ignition off.
- Wait 1 minute.
- Ignition on.
- Wait 1 minute.
- Read out the diagnostic trouble codes in the vehicle.
Check if the diagnostic trouble code is still stored in the control module.
If the fault remains, download new software in Central electronic module (CEM).
Verify according to above method.

Has the fault been remedied?

Yes - No Fault Found

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Information

-------------------------------------------------