Fault-Tracing Information

Fault-tracing

Information
The diagnostic trouble code (DTC) may be stored after downloading software. If this is the case, select CONTINUE and erase the diagnostic trouble code (DTC).
If the diagnostic trouble code (DTC) is notstored when software is downloaded, the cause is probably in the software for the Central electronic module (CEM). Fault-trace the central electronic module (CEM).






Continue - Erasing diagnostic trouble codes (DTCs)

-------------------------------------------------

Checking the diagnostic trouble codes (DTCs)




- Ignition off for 10 seconds and then on again.
- Read off diagnostic trouble codes (DTCs).









Was the relevant diagnostic trouble code (DTC) still stored?

Yes - Fault-tracing information

No - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Information

-------------------------------------------------

Erasing diagnostic trouble codes (DTCs)




- Ignition on.
- Erase diagnostic trouble codes (DTCs).





Continue - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------