Fault-Tracing Information

Fault-tracing

Faulty software
The control module has registered that the information about the vehicle's configuration is not in the control module.
This can be due to a fault in the Central electronic module (CEM).
Remedy the fault by loading new software into the Central Electronic Module (CEM).

Select "Continue" after programming.

Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Does the combined instrument panel work as it should?

Does the combined instrument panel work as it should?

Yes - FAULT FOUND

No - Information

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Faulty software

-------------------------------------------------