Fault-Tracing Information

Fault-tracing information

Checking programming

Note! The diagnostic trouble code (DTC) is stored if the central electronic module (CEM) registers that the software in the engine control module (ECM) is faulty or modified. Neither may software be remedied if the software has been changed by the customer, but this is not the reason for the repair work.

Continue - Downloading new software

-------------------------------------------------

Downloading new software
New software must be downloaded to remedy faulty or modified software in the engine control module (ECM).

Remedy as necessary.

Continue - Fault-tracing information

-------------------------------------------------





Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking programming

-------------------------------------------------