Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information PAM-U007300

Condition
The control modules transmit and receive information via a standardized serial communication method - CAN (Control Area Network).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The control module does not have contact with the controller area network (CAN).
- Incorrect value runs longer than 10 seconds.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Starting the control module's CAN communication.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met. In the event of system communication problems, it is not possible to communicate with the control module. Therefore it will only be possible to read off the fault if it is intermittent.





Substitute value
- None.

Possible source
- Open-circuit in terminals.
- Damaged Parking Assistance Module (PAM).

Fault symptom[s]
- Parking Assistance System, malfunction
- Information lamp is on
- Message in information display