Fault-Tracing Information

Fault-tracing

Checking the gear-shift position sensor




- Check that the gear selector cable is correctly adjusted. Adjust if necessary.
- Ignition on.
- Read off the position of the gear selector.
Shift the gear selector to all gear positions several times. This is to check the function of the gear selector sensor.
The selected position must be the same as that displayed in the diagnostic tool.
If needed, adjust the gear selector wire.

Other information
- Gear selector cable, adjusting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Adjustments









Continue - Calibrating the position sensor in the control module

-------------------------------------------------

Calibrating the position sensor in the control module




- Ignition on.
- Place the gear selector lever in neutral position (N).
Activate calibration of the position sensor in the control module by clicking on the VCT2000 symbol.

Caution! During calibration, it is important that no diagnostic trouble codes (DTCs) for the gear selector module (GSM) are stored and that the gear selector assembly is otherwise free of faults.









Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Verification




Verification




- Ignition off.
- Wait two minutes.
- Ignition on.
- Move the gear selector several times to all gear positions.




- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.

Is the relevant diagnostic trouble code (DTC) still stored?

Yes - No Fault Found

No - FAULT FOUND

------------------------

No Fault Found - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the gear-shift position sensor

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Ignition off.
- Wait two minutes.
- Ignition on.
- Move the gear selector several times to all gear positions.
- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
If present code diagnostic fault code (DTC) remains stored replace the transmission control module (TCM).

Other information









Continue - Verification

-------------------------------------------------