Fault-Tracing Information

Fault-tracing

Checking the line pressure solenoid SLC1




- Ignition on.
- Activate solenoid SLC1 by clicking the VCT2000 symbol.
Read the current through the circuit for solenoid SLC1. The current should oscillate between 100 and 950 mA.
If the current changes, this is an indication that the fault was present previously but is not active at the moment, i.e. an intermittent fault.









Continue - Checking the components and wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Activate solenoid SLC1 by clicking the VCT2000 symbol.
The current should oscillate between 100 and 950 mA.









Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the line pressure solenoid SLC1

-------------------------------------------------

Checking the components and wiring




- Ignition off.
Check connector B (22-pin) for the transmission control module (TCM). Check for damaged or pressed in pins. Check for contact resistance and oxidation.
Check solenoid SLC1, see: Checking internal components of the transmission, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Checking Internal Components Of The Transmission
No fault detected. Replace the transmission control system.

Other information
- Breakout box, connecting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Connecting The Breakout Box, Transmission Control Module (TCM)
- Signal specification, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Signal Specification, Transmission Control Module (TCM)
- Checking wiring and terminals Checking Wiring And Terminals
- Valve housing, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Valve Housing









Continue - Verification

-------------------------------------------------