Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-P261000

Condition
Central electronic module (CEM) sends information via the CAN-net about how long time has passed since the engine was turned off the last time.
The Engine control module (ECM) checks that the time display that the Central electronic module (CEM) transmitted at the last engine shut-off is not greater than the one transmitted at engine start-up.
The diagnostic trouble code can be diagnosed when the ignition is on.

Hint: If the time display is less at start than at the last engine shut-off, this means that the time has been reset.

Substitute value
- The calculated time is used.

Possible source
- Malfunction detected by central electronic module (CEM).

Fault symptom[s]
- Nothing.