Fault-Tracing Information

Fault-tracing

Replacing the transmission
The transmission control module (TCM) has registered an internal fault in the transmission. Replace the transmission.

Other information
- Removal: Transmission, B6324S5, TF-80SC, B6324S4, TF-80SC , B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S4, TF-80SC AWD Transmission
- Installation: Transmission, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S4, TF-80SC AWD , B6324S5, TF-80SC, B6324S4, TF-80SC Transmission





Continue - Resetting the adaptation and oil quality counter

-------------------------------------------------

Resetting the adaptation and oil quality counter





Resetting adaptation

Resetting the adaptation and the counter for "Transmission oil, replace"

Hint: The transmission has torque-regulated, adaptive pressure regulation. The pressure regulator enables the transmission to regulate pressure during each shift to prevent hard shifting. Each shift is assessed by the transmission control module (TCM) and is stored in the internal memory. This makes it possible to compensate for transmission and clutch wear. It is important that the adaptation in the memory is reset so that the transmission works normally after the repair. Because the fluid was changed during the repair, the counter for transmission fluid change must also be reset. If the counter is not reset during draining/replacement, a diagnostic trouble code may be generated under the wrong conditions.

Note! This applies only if the transmission or one of the components in the transmission have been replaced.




- Ignition on.
Click on the VCT2000 symbol to reset the adaptation and counter.





Continue - DONE

------------------------

DONE - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- The gear shift position sensor for the transmission must be calibrated if the control module has been disconnected.


- Start the engine.
Test drive the vehicle following: Test drive schedule, description, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Test Drive Schedule, Description
Check that the transmission does not display any obvious function faults.

Note! When test driving, the oil temperature must be above 20 °C.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the transmission

-------------------------------------------------