Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P097400

Condition
Shift solenoids S1 and S2 work with the linear solenoids to handle shifting in the transmission. The solenoids are controlled by power stages in the transmission control module (TCM). The control module activates the power stages to activate the solenoids and sends voltage through the circuit. The control module checks the function of the circuit by sending out a control current when the solenoid is not activated.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- No signal in the circuit of solenoid S1 when the solenoid is not activated.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Driving in geartronic.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Auxiliary program Emergency mode 3 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Emergency Mode In Case Of Malfunction

Possible source
- Contact resistance in the terminals.
- Open circuit on control signal lead.
- Shift solenoid not working.
- Short-circuit to supply voltage in the signal cable.
- Internal fault in the transmission control module (TCM).

Fault symptom[s]
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication
- Text window and warning symbol/Yellow symbol and text message
- Automatic transmission/No automatic gearshift
- Automatic transmission/Shifts rough or jerky/Unsure when/at all times
- Automatic transmission/No manual gear shift
- Automatic transmission/Lockup does not work
- Driving/Poor performance/lacks power