Fault-Tracing Information

Fault-tracing

Checking the status




- Ignition on.
- Gear selector in position P.
Try moving the gear selector to another position without depressing the brake pedal. It should not be possible to move the gear selector.
Depress the brake pedal and try moving the gear selector to another position. It should now be possible to move the gear selector.
If the gear selector function is OK, this is an indication that the fault was present previously but is not active at the moment, i.e. an intermittent fault.

Continue - Checking the component

-------------------------------------------------

Checking the component




Check the cable for short-circuit to ground.
Take readings between:
- Solenoid for P-position lockout and Gear selector module (GSM).
Check the solenoid's resistance by connecting an ohmmeter between terminals #1 and #2 on the solenoid's connector.
For the resistance values, see below. Replace the solenoid if the resistance is incorrect.

Other information
- Checking wiring and terminals Checking Wiring And Terminals
- Component specifications, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC [1][2]Control Module, A/T





Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Gear selector in position P.
Try moving the gear selector to another position without depressing the brake pedal. It should not be possible to move the gear selector.
Depress the brake pedal and try moving the gear selector to another position. It should now be possible to move the gear selector.

Was the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------