Fault-Tracing Information

Fault-tracing

Checking communication with the gear selector module (GSM)




- Ignition on.
- Read off the position of the gear selector.
- Depress the brake pedal. Move the gear selector to the position for manual shifting and check that the status changes.
- Then move the gearshift selector toward both + and -, and check that the value has been updated in the driver information module's display window.
If the value is updated in the driver information module display, the fault is intermittent. That is to say, it occurred earlier but is not active right now.









Continue - Checking the wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Read off the position of the gear selector.
- Depress the brake pedal. Move the gear selector to the position for manual shifting and check that the status changes.
- Then move the gearshift selector toward both + and -, and check that the value has been updated in the driver information module's display window.





Does the value change?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking communication with the gear selector module (GSM)

-------------------------------------------------

Checking the wiring




- Ignition off.
Check if there are any external sources of interference near the communication cable (LIN) between the transmission control module (TCM) terminal #A7 and gear selector module (GSM) terminal #2 which can disturb communication.
Check the communication cable (LIN) for intermittent short circuits or open circuit.
Take readings between:
- Transmission control module (TCM) terminal #A7 and gear selector module (GSM) terminal #2.

Other information
- Breakout box, connecting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Connecting The Breakout Box, Transmission Control Module (TCM)
- Signal specification, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Signal Specification, Transmission Control Module (TCM)
- Checking wiring and terminals Checking Wiring And Terminals









Continue - Verification

-------------------------------------------------