Fault-Tracing Information

Fault-tracing

Checking the start inhibitor status




- Ignition on.
- Depress the brake pedal.
- Read off the status of the start inhibitor.
Move the gear selector between the positions P, R, N and D.
In positions P and N, the status must be "Start permitted"; in other positions the status must be "Start not permitted".
The fault is permanent if the function is faulty.
If the function is correct, this is an indication that the fault was present previously but is not active at the moment, i.e. an intermittent fault.









Continue - Checking the wiring and sensors

-------------------------------------------------

Checking the wiring and sensors




- Ignition off.
Check the cable for a short-circuit to supply voltage.
Take readings between:
- Transmission control module (TCM) terminal #A5 (#A35) and engine control module (ECM).
Remedy as necessary.

Other information
- Breakout box, connecting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Connecting The Breakout Box, Transmission Control Module (TCM)
- Signal specification, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Signal Specification, Transmission Control Module (TCM)
- To access connector A:
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Read off the status of the start inhibitor.
Move the gear selector between the positions P, R, N and D.
In positions P and N, the status must be "Start permitted"; in other positions the status must be "Start not permitted".





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the start inhibitor status

-------------------------------------------------