Fault-Tracing Information

Fault-tracing

Calibrating the position sensor in the control module




- Check that the gear selector cable is correctly adjusted. Adjust if necessary.
- Ignition on.
- Place the gear selector lever in neutral position (N).
Activate calibration of the position sensor in the control module by clicking on the VCT2000 symbol.

Other information
- Gear selector cable, adjusting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Adjustments









Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Calibrating the position sensor in the control module

-------------------------------------------------

Verification




- Ignition off.
- Wait two minutes.
- Ignition on.
- Move the gear selector several times to all gear positions.
- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
If present code diagnostic fault code (DTC) remains stored replace the transmission control module (TCM).

Other information









Is the relevant diagnostic trouble code (DTC) still stored?

Yes - Fault-tracing information

No - FAULT FOUND

-------------------------------------------------