Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P070668

Condition
So that the selected gear position is always correct, the gear selector cable must be fitted, adjusted and then calibrated correctly.
The diagnostic trouble code (DTC) is stored if the control module detects:
- Incorrect signal from the gear selector sensor.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Gear selector cable fitted incorrectly.
- Gear position sensor is not calibrated.

Fault symptom[s]
- Text window and warning symbol/Yellow symbol and text message