Fault-Tracing Information

Fault-tracing

Checking the components and wiring








- Ignition off.
Check the cable between engine control module (ECM) #B16 (#C16) and battery for open circuit, contact resistance or oxidation.
Remedy as necessary.

Other information
- Connecting the breakout box, B6304T4 Connecting The Breakout Box, Engine Control Module (ECM)
- Engine control module (ECM), B6304T4, B6324S5, B6324S4 Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the components and wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Start the engine.
Read off the battery voltage.
Check the battery voltage, battery voltage shall be 13.5 V-14 V.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------