Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




Engine control module (ECM) checks the signal from the air temperature sensor (integrated in boost pressure sensor) which is located between the turbocharger and the throttle module.

Note! The boost pressure sensor and air temperature sensor are integrated in the same component, the boost pressure sensor.

The diagnostic trouble code (DTC) is stored if the control module detects that:
- Control signal is too high.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.
- Battery voltage higher than 10.5 V.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- Value from the engine intake air temperature (IAT) sensor in the intake manifold is used.
- Fuel trim disabled.

Possible source
- Short-circuit to supply voltage in the signal cable.
- Damaged air temperature sensor (integrated in boost pressure sensor).

Fault symptom[s]
- Malfunction indicator light (MIL), on