Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information FSM-C113212

Condition
The Forward Sensing Module (FSM) supplies power to the visual collision warning indicator directly via an output.

The diagnostic trouble code (DTC) is stored if the control module detects that:
- Power consumption for the output is too low.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Control module supplied with power for at least 5 seconds.
- The system voltage is greater than 8.0 V.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Short-circuit to supply voltage in the signal cable.

Fault symptom[s]
- 1T, Warning lights and chimes/Front monitoring/Active safety indication/no indication
- CJ, Warning lights and chimes/Bulb failure indication/no indication