Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-C110812

Condition
The Central electronic module (CEM) supplies voltage to the clutch pedal position sensor and the accelerator pedal position sensor.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Short-circuit to supply voltage in the cable.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Cruise control shut off.
- The function switches off permanently after 100 operating cycles where the fault was detected. Erasing diagnostic trouble codes (DTCs) resets the result.

Possible source
- Short-circuit to supply voltage in the signal cable.

Fault symptom[s]
- Cruise control does not operate