FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Volvo >> 2013 >> XC60 R Design AWD L6-3.0L Turbo VIN 90 B6304T4 >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> C Code Charts >> C0064 >> C006428 (Brake Control Module - BCM) >> Diagnostic Trouble Code (DTC) Information

Diagnostic Trouble Code (DTC) Information






Diagnostic trouble code (DTC) information BCM-C006428

Condition

Note! The diagnostic trouble code (DTC) only applies to vehicles with roll control (RSC).

The Body sensor cluster stability sensor (BSC) provides the Brake control module (BCM) with information about the lateral acceleration, the forward acceleration and yaw-angle speed of the vehicle. The Body sensor cluster stability sensor (BSC) transmits the information to the Brake control module (BCM) via the internal controller area network (CAN). Each sensor has an offset value, correction value, for the individual sensor offset.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The offset value, when compared to the saved value, is outside its permitted range.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Traction control (TC) blocked.
- Stability control (SC) blocked.
- Active yaw control (AYC) is blocked.
- Roll control (RSC) blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- Body sensor cluster (BSC) is incorrectly installed.
- Body sensor cluster (BSC) is loose.
- Bracket for the body sensor cluster (BSC) is bent.
- Internal fault in the body sensor cluster (BSC).

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- Anti-spin function/Does not work
- Front monitoring/Active safety/City Safety does not work
- Brake pedal/Excessive "brake pedal effort" required
- Cruise control/Does not engage
- Front monitoring/Active safety/City Safety does not work
- Stability function/Does not work
- Warning lights and chimes/Antispin/antiskid (DSA, TRACS, STC, DSTC) indication/no indication

pro multis Credits:Operation CHARM About Operation CHARM