Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
The yaw rate sensor, lateral acceleration sensor and acceleration sensor are integrated in the body sensor cluster stability sensor (BSC). The sensors measure the yaw rate, the vehicle's lateral acceleration and forward acceleration. The stability sensor then transmits the information to the Brake control module (BCM) via the internal controller area network (CAN). Each sensor has an offset value, correction value, for the individual sensor offset.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The signal during comparison does not correspond with the calculated value.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.
Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.
Substitute value
- Traction control (TC) blocked.
- Stability control (SC) blocked.
- Active yaw control (AYC) is blocked.
Hint: Brake system, abbreviations Brake System, Abbreviations
Possible source
- Body sensor cluster (BSC) is incorrectly installed.
- Body sensor cluster (BSC) is loose.
- Bracket for the body sensor cluster (BSC) is bent.
- Internal fault in the body sensor cluster (BSC).
Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
- Anti-spin function/Does not work
- Brake pedal/Excessive "brake pedal effort" required
- Cruise control/Does not engage
- Front monitoring/Active safety/City Safety does not work
- Stability function/Does not work
- Warning lights and chimes/Antispin/antiskid (DSA, TRACS, STC, DSTC) indication/no indication
- Front monitoring/Active safety/Adaptive cruise control does not work
- Front monitoring/Active safety/Collision warning with brake support does not work