Fault-Tracing Information

Fault-tracing

Checking the wiring








- Ignition off
- Disconnect the antenna connector.
Check the terminal. Check for contact resistance. Check for loose connections. Check for oxidation.
Check the cable harness and the contact ring to the band-3 antenna.
Remedy as necessary.

Other information
- Component location, Remote Digital Audio Receiver (DABM) Component Location, Remote Digital Audio Receiver (DABM)
- Signal specification, Digital Audio Broadcast Module (DABM) Signal Specification, Digital Audio Broadcast Module (DABM)
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the radio is working and that the reception is acceptable.

Is the radio playing through the loudspeakers?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------