Fault-Tracing Information

Fault-tracing

Select an alternative
- If the diagnostic trouble code (DTC) is permanent: Select alternative 1.
- If the diagnostic trouble code (DTC) is intermittent: Select alternative 2.

Select an alternative.

1 - Checking components and connections

2 - Intermittent fault

-------------------------------------------------

Intermittent fault




- The fault has been remedied.

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Select an alternative

-------------------------------------------------

Checking components and connections








- Ignition off, wait for 15 seconds.
Check the occupant weight sensor (OWS):
- Check that the components included in the occupant weight sensor (OWS) system are correctly installed.
- Check that the wiring included in the occupant weight sensor (OWS) system is correctly routed.
Remedy as necessary.

Other information
- Occupant weight sensor (OWS): Signal specification Signal Specification, Occupant Weight Sensor (OWS)
- For further information, see the wiring diagram.
- Front passenger weight sensor Removal and Replacement

Was a fault detected?

Yes - Verification

No - Replacing a component

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------

Replacing a component









If no malfunction has been found
- Replace the occupant weight sensor (OWS).

Note! After replacing the occupant weight sensor (OWS), the occupant weight sensor (OWS) must be calibrated.

Other information
- Front passenger weight sensor Removal and Replacement
- Calibrating the occupant weight sensor (OWS) Testing and Inspection

Continue - Verification

-------------------------------------------------