Fault-Tracing Information

Fault-tracing

Fault-tracing information





Checking components and connections
Check that the components included in the occupant weight sensor (OWS) system are correctly installed.
If no fault is found, replace the occupant weight sensor (OWS).

Replacing a component
- Ignition off, wait for 15 seconds.
- Replace the occupant weight sensor (OWS).

Note! After replacing the occupant weight sensor (OWS), the occupant weight sensor (OWS) must be calibrated.

Other information:
- Calibrating the occupant weight sensor (OWS) Testing and Inspection
- Front passenger weight sensor Removal and Replacement
- Occupant weight sensor (OWS): Signal specification Signal Specification, Occupant Weight Sensor (OWS)
- Supplemental restraint system module (SRS): Signal specification, supplemental restraint system module (SRS) Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.

Continue - Verification

-------------------------------------------------





Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------