Sealing Ring, Bevel Gear, Left

Operation number: 43335-2

Sealing ring, bevel gear, left

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Removing bevel gear
Remove the bevel gear. Refer to: Bevel gear, TF-80SC AWD Bevel Gear, Replacing.





999 7086 Puller 999 7086 Puller.

Note! Check thoroughly that no seal residue remains.





Position the bevel gear over a receptacle.
Allow the oil to run out through the bearing.
Clean any spilled oil from the seal ring seat in the bevel gear using a lint-free cloth.

Installation






Install:
- 999 7189 Drift 999 7189 Drift
- the gasket.





999 7189 Drift 999 7189 Drift.

Note! When the tool is removed, check that 999 7189 Drift 999 7189 Drift was removed with it.

Installing the angle gear
Install the bevel gear. Refer to: Bevel gear, TF-80SC AWD Bevel Gear, Replacing.

Finishing

Checking the oil level




Check the oil level in the bevel gear.