Installation Kit Child Seat

Installation kit child seat



























INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Installation kit child seat

Warning! This installation kit must NOT be mounted on the front seat on the passenger side in cars equipped with Supplemental Restraint System Module (SRS) (airbag). Child seats must NOT be mounted in the front seat on the passenger side in cars equipped with Supplemental Restraint System Module (SRS) (airbag).

Note! It is recommended that this installation is carried out at a Volvo workshop.

Preparations





- Remove the right-hand side panel from the centre console by pulling it off. Start at the front edge and then work backwards until all the clips have released.





- Remove the sill trim panel for the right-hand front door. Pull it off, starting at the front edge, until the clip there has released. Continue backwards until the remaining clips have released
- Move the sill trim panel to the right in order to fold the carpet away from the right-hand side of the bodywork.

Installing the right-hand mounting





- Push the floor carpet to one side
- Enlarge the existing hole (1) in the bodywork. Use a 13 mm (33/64") diameter drill bit
- Smooth off and rust-proof the edges of the hole.





- Take the rivet nut from the kit. Place the rivet nut on the rivet nut tool (P/N 9512782). Install the rivet nut in the drilled hole using the tool. Secure the rivet nut to the bodywork.





- Take the mounting and the M10 and M6 screws from the kit. Secure the mounting to the rivet nut. Secure the weld nut in the bodywork. Tighten the M10 screw. Tighten to 50 Nm (37 lbf. ft.). Tighten the M6 screw. Tighten to 10 Nm (7 lbf. ft.)
- If the car has a passenger compartment connector socket, its bracket must be positioned above the mounting. Secure using the M6 screw.





- Fold back the carpet under the mounting. Using a pen, mark on the carpet the position of the lower edge of the mounting eyelet.





- Use a carpet knife. Cut vertically upwards from the marked point. Cut equal to the width of the mounting eyelet.





- Fold back the carpet. Reinstall the sill trim panel.

Installing the left-hand mounting





- Push the floor carpet to one side where the side panel was removed
- Remove the two screws (1) in front of the air duct. Place the screws to one side. They will not be used again. There are new screws in the kit.





- Take the mounting and two M8 screws from the kit. Secure the mounting to the bodywork. Tighten the screws. Tighten to 24 Nm (18 lbf. ft.).





- Fold back the carpet under the mounting. Using a pen, mark where the mounting eyelet is to go through the carpet.





- Use a carpet knife. Make a cut in the carpet directly in front of the marking. Make the cut as wide as the mounting eyelet.





- Fold the carpet back into place
- Reinstall the right-hand side panel on the centre console.