Silencer, Rear, Replacement

Silencer, rear, replacement

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the rear silencer




Measure 235 mm from the front silencer's rear end face in accordance with step A in the illustration.
Mark and cut the pipe, use pipe cutter 115 8590 PIPE CUTTER 115 8590 Pipe Cutter.

Remove:
- the rubber mountings, x3
- the silencer.

Applies to second-time or later replacements.

Remove:
- the nut to the clamp between the front and rear silencer
- the rubber mountings, x3
- the silencer.

Installation

Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling Removal and Replacement.

Installing the rear silencer

Install:
- a new silencer
- the rubber mountings, x3
- the nut, M10, to the clamp between the front and rear silencer.