Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code information BCM-C111154

Condition





Note! The diagnostic trouble code only applies to vehicles equipped with DSTC.

When calibrating sensors that are part of active yaw control (AYC), a checksum is stored in the brake control module (BCM). At start-up, the control module checks the stored checksum against a calculated checksum.
Diagnostic trouble code BCM-C111154 is generated if the checksums do not match.
The diagnostic trouble code can be diagnosed when the ignition is on.

Substitute value
- TC is blocked.
- SC is blocked.
- AYC is blocked.

Hint: For information on abbreviations: Brake system, abbreviations, B6324S5 Testing and Inspection

Possible source
- Damaged brake control module (BCM).

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- General warning light on.
- Anti-spin is not operational.
- The stability function is not operational.
- The anti-skid function is not operational.