Child Seat, Mounting Eyelets
Child seat, mounting eyelets
INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
Child seat, mounting eyelets
Applies to cars with a passenger compartment connector socket
- Remove the locking sleeve at the front edge of the passenger compartment connector.
- Remove the screws in the passenger compartment connector, detach the cable and place it to one side.
- Remove the tunnel console's right-hand side panel by carefully pulling it away starting at the rear edge. The panel is secured with five clips on the inside.
- Fold the carpet to one side.
- Fold the insulation panel back from the centre console's right-hand mounting.
- Remove the two screws in the centre console mounting and place them to one side. There are new screws in the child seat mounting.
- Take the larger of the mountings from the kit and tighten it into the holes for the tunnel console mounting.
- Torque tighten the screws to 25 Nm (18.5 lbf.ft.).
- Fold the insulation panel back over the mounting.
- Fold the floor carpet back and thread the mounting through the hole in the carpet.
Applies to cars with a passenger compartment connector socket
- Connect the cable to the passenger compartment connector socket and install the locking sleeve over the join.
- Tighten the passenger compartment connector socket to the console.
- Reinstall the tunnel console panel.
- Remove the right-hand end face panel from the dashboard.
- Remove the sill trim panel in the right-hand front door by first prizing it off at the front edge using a weatherstrip tool. Following which, pull it up until the three clips underneath release and then pull it forward/up.
- Detach the rubber strip at the front edge of the door opening by the lower A-pillar panel.
- Remove the lower A-pillar panel in the right-hand front door by first pulling it up at the rear edge until the clips there release. Pull it back further until the clip on the centre releases and then pull it away diagonally down from the A-pillar panel.
- Fold the carpet to one side.
- Detach the holder for the connectors, it is fitted with two clips.
- Fold the insulation panel to one side.
- Take the remaining bracket from the kit.
- Install the mounting with the screw in the upper hole and the guide pin in the lower hole in the front edge of the right-hand door opening.
- Torque tighten the screw to 10 Nm (7.5 lbf.ft.).
- Fold back the insulation panel against the mounting which is to be threaded through the hole in the insulation panel.
- Reinstall the holder for the connectors.
- Fold the floor carpet back and thread the mounting through the hole in the carpet.
- Reinstall the lower A-pillar panel.
- Reinstall the rubber strip in the door opening.
- Reinstall the sill trim panel.
- Reinstall the dashboard end face panel.