Interior Moulding / Trim: Service and Repair

Glasses holder, entry handle



























INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Glasses holder

Note! Some steps in these installation instructions are presented with illustration only.





- Prise up the cover on the grab handle above the door.
- Remove the screws and carefully pull the grab handle until the retaining plate on the inside releases. Put the handle aside. The screws will be reused.





- Take the glasses holder from the kit.
- Fit the glasses holder where the grab handle sat.
- Make sure that the four retaining plates (1) sit on each side of the nut plates where the glasses holder will be fastened. If there is not enough room for the plate, it can be broken off and discarded.