Part 2

Navigation system, portable































































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Navigation system, portable

Illustrations A and B




- Route the cable harness from the 12V socket through the centre console.
Use tension spring P/N 9512932.






Right-hand drive vehicles




- Route the cable harness forward inside the mat, through the centre console, up through the dashboard and out to the left at the combined instrument panel.
Use tension spring P/N 9512932.

Applies to all models




- Clamp the cable at the existing cable harness. Conceal any overlength cable inside the mat.





- Connect the connectors.





- Remove the protective tape and wrap the foam around the connectors.





- Clamp the foamed connectors and cable harness and any overlength at the existing cable harness.

Note! Divide the excess evenly, in order not to obstruct the combined instrument panel.







- Reinstall the detached components in reverse order.

Applies to the XC60

Note! In instances where installation kit TMC is to be installed, perform this at the same time.





- Set the ignition key to position 0.

Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.














- Remove the marked components.





- Remove the screws.





- Remove the marked components.
- Unplug the connector.





- Remove the rubber strip.





- Remove the screw.





- Remove the panel.










- Cut out the discs.





- Place the mounting A over the drilled hole.





- Centre the hole in the mounting (A) opposite the drilled hole in the panel.
- Adjust the mounting so that it is fully against the panel and hold securely.
- Drill out the two holes.










- Carefully drill out the mounting and panel.
- Drill horizontally.





- Remove the screws.





- Adjust the cable length so that the end of the marking is as illustrated.





- Adjust the cable length so that the end of the marking is as illustrated.





Installing holder

Note! Be sure to position the mounting (A) so that it is against the panel.


Illustrations A and B




- Insert the cable harness in the dashboard.
Use tension spring P/N 9512932.






Illustrations A and B




- Reinstall the panel.










Applies to all vehicles
- Remove the panel.

Right-hand drive vehicles
- Applies to both sides.